914Rubber Tribal Knowledge Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

**REPLACE TRAILING ARM PIVOTS AND WHEEL BEARINGS**

Another episode from Ian Karr's restoration of a Porsche 914 LE ”Bumblebee” in his home garage. In this episode (number 15), he replaces the trailing arm pivots and wheel bearings. And while the parts are at the powder coater, he finally installs the dash (restored in episode 4), routes the harness and installs the switches.  

{{youtube>n37Yx7Nxil8?large}}

Parts used:

[[https://914rubber.com/solid-stainless-steel-trailing-arm-pivot-shaft-set-for-porsche-914|Pivot Shaft set from 914Rubber]]

[[https://914rubber.com/rear-trailing-arm-bushing-for-porsche-914|Rear Trailing Arm Bushing from 914Rubber]]

[[https://vwparts.aircooled.net/Dash-Switch-Escutcheon-Tool-Fits-10-12-and-14mm-p/escutcheon-tool.htm|Dash Switch Tool from Aircooled]]